To use the UC100 parallel port to USB driver you will need to make the following settings changes:
Open Config – Ports & Pins – Motor Outputs
Make changes as per this screen (disable the B Axis):
Download and run the driver from http://cncdrive.com/MC/UC100%20full%20auto%20installer/UCx00setup.exe
When asked, make sure ‘Mach3’ is selected.
Cutting rules in SheetCAM are a powerful way to fine-tune your cutting results. You can add a ruleset from the…
To migrate your Design Edge licence, or reactivate it on another PC, you will need to request that the licence…
TEST 1:Turn off the power Remove the Z-axis motor. Loosely reattach just the motor body using two opposite bolts. Hold…
For more information on our products, services, and solutions, and to get pricing, please click on the button below.